$8,100.00
• Most economical Winezone Ductless Split system to purchase and install
• Winezone Ductless Split allows the transfer of heat to a room not adjacent to the cellar
• This Winezone unit is perfect for both long storage as well as commercial applications where the wine will be turned over quickly
• For rooms already constructed, rooms with concrete or brick walls, and rooms without space for ducting
• For cellars without access to a mechanical room to house an air handler
• Winezone unis can be used with either an indoor or outdoor remote condensing unit, moving heat and noise away from the cellar
• Extremely quiet, attractive, wall-mounted evaporator
• Attractive, 24V digital thermostat with large display controls the system
• Must be installed and adjusted by a qualified HVAC technician
Ductless Evaporator:
• Low noise evaporator fan and remote condenser design
• Economical way to cool, even where installing ductwork is impractical or impossible
• Requires only one small hole through the wall to run lines for refrigerant, electric, and condensate drain
• Washable filters
• Stylish grille cover is easily detached and cleaned
• UL listed Copeland® commercial condensing unit.
• Uses R-134a refrigerant
• Air-cooled units standard
• Receiver for use with thermostatic expansion valve
• 4″ galvanized iron base
• Variable speed fan control
• Crankcase heater on all models
• UL listed Copeland® commercial condensing unit.
• Uses R134a refrigerant
• Air-cooled units standard
• Receiver for use with thermostatic expansion valve
• Rainproof control panel box with liquid-tight conduit on the control panel
• Low ambient controls
• Variable speed fan control
• Crankcase heater on all models
• UL Listed enclosure
• Galvanized steel base
• 20 GA. Galvanized steel cabinet
• Hinged access for easier servicing
• Wind safety latch
• All-season weather protection
• Front louvers at a 45° angle
• Rain trough under hinge to catch moisture that might seep through hinge
• Condenser screen protected with high-temperature baked-on clear lacquer coating
6000
The BTU/h value shown here is a theoretical number. There are often circumstances under which a cellar design may require a larger unit due to variables not accounted for in the formula. For example, these variables could be building materials (such as glass, stone, concrete, etc.)
Which do not offer the insulation capacity required to maintain the optimal cellar environment. We recommend purchasing a unit with a larger capacity to compensate for these unaccounted-for variables. An undersized unit can lead to premature failure and will most likely prevent the cellar from reaching your desired temperature.
• Attractive styling complements any décor
• Large display for easy readability
• Keys are located by the display for easy access
• Easy installation, setup, and self-test save the installer time
• Set points permanently held in memory and are retained during power outages
Condenser:
Voltage Ampacity Max. Fuse Min. Wire Size RLA/LRA dB
230/208-60-1 8.7 15 12-2 w/Gr 6.5/35 53
➢ 5/16″ x 5/8″ line set. 200 equivalent feet maximum. See the installation instructions for line set sizing up to 200 equivalent feet maximum.
➢ Unit is not precharged and must be evacuated
➢ For use with R-134a refrigerant.
➢ Indoor condensers must be installed in a room with a minimum of 1240 cubic feet of free space
➢ Dimensions:
Indoor Unit: 25” L x 20” W x 18 1/2” T 100 lbs.
Outdoor Unit: 27 ”L x 20” W x 20” T 126 lbs.
Wall-Mounted Evaporator:
Voltage Motor Output Filter dB
208/240-60-1 48 Watts Washable 42
➢ Receives load voltage from condenser
➢ Drain line is 5/8” barbed
➢ Dimensions: 42 5/8” W x 12 3/8” H x 9” D 31.8 lbs
Thermostat:
➢ PRO 1 or Peco 12532 if ordered with humidifier
➢ 18-gauge 5-wire to the condenser
Approximate Shipping Weight: 279-327 lbs.
Crate Size: 36” x 49” x 44” T
Showroom Available By Appointment
Established 2014 Copyright ©2024 Cool Wine Cellar. All Rights Reserved
