$900.00
CellarPro 2000 VS Duct KIT (Cold Side) Low RH (P/N 27104). Duct openings are designed to attach to 2 insulated 8-inch ducting for evaporator intake and exhaust. Custom design allows access to controls and switches on the face of the cooling unit.
The exhaust exits from the top, and the intake returns from the front.
CellarPro 2000 VS Duct KIT (Cold Side) Low RH (P/N 27104). Duct openings are designed to attach to 2 insulated 8-inch ducting for evaporator intake and exhaust. Custom design allows access to controls and switches on the face of the cooling unit.
The exhaust exits from the top, and the intake returns from the front.
Shown at left: cold side duct kit (left) AND hot side duct kit (right). The hot side duct kit must be purchased separately.
Kit includes: Duct hoods for cold side intake and exhaust, 50 feet (2×25) of 8-inch insulated (R-6) ducting, remote display and bottle probe.
The high fan speed setting is required when our unit is ducted.
This cold side kit is designed to work with CellarPro 2000VS cooling units, allowing the cold air intake and exhaust to be ducted up to 50 equivalent feet (25 feet per opening).
Please note: the high-humidity duct kit must be used if the cooling unit will be installed in a warm, moderate, unconditioned or high humidity environment. Our high-humidity kit includes insulation on the hood, inside the unit and on its face to prevent moisture buildup and damage.
Brand: CellarPro
Size: As installed: 14 1/4w x 3 3/4d x 12 1/2h (in)
Weight: 35 lbs
Capacity: 50 Equivalent Feet
Warranty:
1 Year
Please refer to the following resources before purchasing this kit:
This kit may only be used in conditioned, low humidity environments. Use our Low RH vs High RH Duct Kit Chart to determine whether this kit is appropriate for your installation. In some cases, the high-humidity duct hood may be required, and in some cases, the conditions are too extreme for any of our cold-side duct kits.
Use our ducting heat loss table and our duct correction table to correctly adjust the sizing of your cooling unit, because ducting will add to the thermal load of the cellar.
Refer to our Bottle Probe Operating Instructions to correctly set the cooling unit depending on how you’re using the Bottle Probe
Click on one of the following links for more information:
Showroom Available By Appointment
Established 2014 Copyright ©2024 Cool Wine Cellar. All Rights Reserved
