Condensate Pump Kit (P/N 17297). When the condensate pump is attached to the drain line, water from the cooling unit will accumulate in the condensate pump until the pump’s float switch is activated. At that point, the pump becomes energized and will move the water to the final drain.

The pump attaches to a 1/2-inch ID line from the cooling unit, and pumps the condensate through a 3/8-inch ID line. This kit includes 25 feet of 3/8-inch ID line.

The unit can pump water up to 100 horizontal feet or 13 vertical feet (please refer to our graph under the “Resources” tab below for points in between).

Includes a 1/2 gallon collection tank. Includes check valve and safety switch. Requires a 110V power outlet. May be used on the same circuit as CellarPro cooling units.
Power cord is 6-feet long.

Specs & Resources

Brand: CellarPro

Size: 6 1/2w x 12 1/4d x 7 3/4h (in)

Weight: 7 lbs

Power/Rating:
– 1/40 HP
– 1 Amp / 115V AC / 60Hz

Warranty:
1 Year

• Barbed fitting for 1/2-inch ID tube connection (outlet)
• 3 x 1-1/4-inch openings (inlet)
  – Kit includes pump + 25-feet 1/2-inch ID outlet tubing
• 10-feet of inlet tubing is included with VS, Split and Air Handler systems

Features

Use our condensate pump to move condensate for installation conditions that will not accommodate a gravity drain line.

• Pump up to 100 horizontal feet or 13 vertical feet
• 25-feet of outlet tubing included
• 1/2 gallon collection tank
• Check valve and safety switch
• 6-foot power cord
• May be used on the same circuit as CellarPro cooling units